HPE ProLiant DL170e G6 Parts
Unique Options

NOTE: This cable kit is only required when upgrading with a Smart Array P410 Controller after initial purchase.
NOTE: Supports SAS and SATA drives when using Smart Array P410 Controller.

NOTE: This cable kit is only required when upgrading with any Smart Array Controller other than the P410 after initial purchase.
NOTE: Supports SAS and SATA drives when using any Smart Array Controller other than the Smart Array P410 Controller.
CHF 124
CHF 93.20

NOTE: This kit is required when installing a NVIDIA card in the DL170e 2U server node.

NOTE: This kit is required after initial purchase when shipping a DL2000 in a rack with 1U or more of space above it from one location to another.
Memory
Registered DIMMs (RDIMMs)
CHF 40
CHF 31.07
CHF 44
CHF 31.07
CHF 41
CHF 31.88

NOTE: Low Voltage DIMMs can only be used with Intel® Xeon® processor 5600 series processors.
CHF 66
CHF 53.14
CHF 55
CHF 39.24
CHF 46
CHF 31.88

NOTE: Low Voltage DIMMs can only be used with Intel® Xeon® processor 5600 series processors.
CHF 46
CHF 31.88
Unbuffered with ECC DIMMs (UDIMMs)
NOTE: Maximum 12 DIMMs supported per node.
CHF 54
CHF 36.79
CHF 55
CHF 39.24
NOTE: PC3L is a low voltage memory.
NOTE: Memory DIMM blanks are required in any empty DIMM slots for proper cooling. If DIMMs are removed or the memory configuration is changed, all DIMM slots must be populated with either a blank or a DIMM.
NOTE: There is a maximum support limitation of 8 ranks per memory channel (maximum of 2 quad rank DIMMs per channel)
NOTE: Memory Min and Max depends on number of processors and type of memory:
1. Processor -> R-Dimm: Min 1 // Max 8 U-Dimm: Min 1 // Max 6
2. Processors -> R-Dimm: Min 2 // Max 16 U-Dimm: Min 2 // Max 12
Drives
NOTE: The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated down to an acceptable level for all components.
NOTE: To support HPE hard drives exceeding 2.2 TB, HPE Smart Array Firmware version 5.0 or later is required for the following controllers:
To use hard drives exceeding 2.2 TB, you must create a boot volume using offline ACU version 8.75 or later. HPE Smart Array controllers do not support boot volumes exceeding 2.2 TB.
Other controllers are not supported.
SAS Hot Plug SFF (2.5-inch) Enterprise (ENT) Drives
CHF 106
CHF 77.66
SAS Hot Plug LFF (3.5-inch) Enterprise (ENT) Drives
CHF 204
CHF 137.34
CHF 246
CHF 175.76
SAS Hot Plug SFF (2.5-inch) Midline (MDL) Drives
CHF 152
CHF 104.64
SAS Hot Plug LFF (3.5-inch) Midline (MDL) Drives
CHF 81
CHF 64.58
SATA Hot Plug SFF (2.5-inch) Midline (MDL) Drives
CHF 68
CHF 47.42
SATA Hot Plug LFF (3.5-inch) Midline (MDL) Drives
CHF 114
CHF 80.12
CHF 132
CHF 94.01
CHF 115
CHF 89.11
CHF 63
CHF 44.96
6G SAS ME Hot Plug SFF (2.5-inch) Enterprise Mainstream Solid State Drives
CHF 400
CHF 285.31
CHF 491
CHF 350.71
6G SAS SLC Hot Plug Enterprise Performance Solid State Drives
Networking
Gigabit Ethernet adapters
CHF 66
CHF 48.23
CHF 135
CHF 102.19
CHF 86
CHF 62.13
CHF 132
CHF 94.01
CHF 59
CHF 44.96
10 Gigabit Ethernet Adapters
NOTE: A minimum of two Gigabytes (2 GB) of server memory is required per each adapter.
NOTE: Direct Attach Cable (DAC) for copper environments or fiber transceivers and cables for fiber-optic environments must be purchased separately.
InfiniBand
CHF 75
CHF 52.32
CHF 276
CHF 224.81
Power Supplies
NOTE: - Prior to making a power supply selection it is highly recommended that the HPE Power Advisor is run to determine the right size power supply for your server configuration. The HPE Power Advisor is located at:- (link)
CHF 199
CHF 137.34

NOTE: Option Kits contain optional power supply, an IEC power cable and PDU IEC cables.
CHF 150
CHF 112.82
Storage Controllers
HPE Smart Array P212 Controller
HPE Smart Array P410 Controller
CHF 99
CHF 58.04
CHF 151
CHF 120.99
CHF 208
CHF 151.24
HPE Smart Array P411 Controller
CHF 283
CHF 165.95
CHF 427
CHF 326.18
Smart Array P812 Controller
Optional Upgrades

NOTE: This cable kit is only required when upgrading with a Smart Array P410 Controller after initial purchase.
NOTE: Supports SAS and SATA drives when using Smart Array P410 Controller.

NOTE: This cable kit is only required when upgrading with any Smart Array Controller other than the P410 after initial purchase.
CHF 124
CHF 93.20
NOTE: Supports SAS and SATA drives when using any Smart Array Controller other than the Smart Array P410 Controller.

NOTE: Supported on HPE Smart Array P212 Controller only.
CHF 34
CHF 23.71
CHF 55
CHF 39.24
CHF 43
CHF 31.88
SAS Controller Options
SCSI HBA
CHF 208
CHF 121.81
Tape Backup
CHF 5,024
CHF 2,947.91
CHF 3,075
CHF 2,186.81
Tape Storage Systems
HPE StoreEver MSL6480
CHF 13,489
CHF 10,218.75
Disk Storage Systems
Disk Enclosures
CHF 7,168
CHF 5,599.88
Storage Options
Storage Fibre Channel HBA
Brocade Fibre Channel HBAs
CHF 145
CHF 85.02
CHF 190
CHF 112.00
Emulex Fibre Channel HBAs
CHF 59
CHF 40.88
CHF 64
CHF 45.78
QLogic Fibre Channel HBAs
CHF 41
CHF 31.07
CHF 70
CHF 49.05
Converged Network Adapter
CHF 145
CHF 105.46
Rack Options
HPE TFT7600 G2 KVM Console and Monitor (TFT7600 G2)
HPE USB Keyboard and Mouse
CHF 118
CHF 80.12
HPE Server Console Switches
HPE Server Console Switch G2 with Virtual Media & CAC
HPE IP Console Switch G2 with Virtual Media & CAC
Rail Kits

NOTE: This kit is required after initial purchase when shipping a DL2000 in a rack with 1U or more of space above it from one location to another.
Processors
NOTE: HPE server processor pricing is volatile and availability is unpredictable. Please select any CPU kit below and click Request Quote and submit the form to get the current pricing for that CPU kit. |
NOTE: All CPU Kits come complete with heatsink, fan(s), etc
Six-Core Processors
CHF 223
CHF 159.41
CHF 303
CHF 215.00
CHF 254
CHF 181.49
CHF 447
CHF 319.64
CHF 244
CHF 174.13
Quad-Core Processors
CHF 509
CHF 363.79
CHF 183
CHF 129.98
CHF 437
CHF 309.83