HPE ProLiant DL170e G6 Parts
Unique Options

NOTE: This cable kit is only required when upgrading with a Smart Array P410 Controller after initial purchase.
NOTE: Supports SAS and SATA drives when using Smart Array P410 Controller.

NOTE: This cable kit is only required when upgrading with any Smart Array Controller other than the P410 after initial purchase.
NOTE: Supports SAS and SATA drives when using any Smart Array Controller other than the Smart Array P410 Controller.
$152
$114.00

NOTE: This kit is required when installing a NVIDIA card in the DL170e 2U server node.

NOTE: This kit is required after initial purchase when shipping a DL2000 in a rack with 1U or more of space above it from one location to another.
Memory
Registered DIMMs (RDIMMs)
$49
$38.00
$54
$38.00
$50
$39.00

NOTE: Low Voltage DIMMs can only be used with Intel® Xeon® processor 5600 series processors.
$81
$65.00
$67
$48.00
$56
$39.00

NOTE: Low Voltage DIMMs can only be used with Intel® Xeon® processor 5600 series processors.
$56
$39.00
Unbuffered with ECC DIMMs (UDIMMs)
NOTE: Maximum 12 DIMMs supported per node.
$66
$45.00
$67
$48.00
NOTE: PC3L is a low voltage memory.
NOTE: Memory DIMM blanks are required in any empty DIMM slots for proper cooling. If DIMMs are removed or the memory configuration is changed, all DIMM slots must be populated with either a blank or a DIMM.
NOTE: There is a maximum support limitation of 8 ranks per memory channel (maximum of 2 quad rank DIMMs per channel)
NOTE: Memory Min and Max depends on number of processors and type of memory:
1. Processor -> R-Dimm: Min 1 // Max 8 U-Dimm: Min 1 // Max 6
2. Processors -> R-Dimm: Min 2 // Max 16 U-Dimm: Min 2 // Max 12
Drives
NOTE: The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated down to an acceptable level for all components.
NOTE: To support HPE hard drives exceeding 2.2 TB, HPE Smart Array Firmware version 5.0 or later is required for the following controllers:
To use hard drives exceeding 2.2 TB, you must create a boot volume using offline ACU version 8.75 or later. HPE Smart Array controllers do not support boot volumes exceeding 2.2 TB.
Other controllers are not supported.
SAS Hot Plug SFF (2.5-inch) Enterprise (ENT) Drives
SAS Hot Plug LFF (3.5-inch) Enterprise (ENT) Drives
SAS Hot Plug SFF (2.5-inch) Midline (MDL) Drives
SAS Hot Plug LFF (3.5-inch) Midline (MDL) Drives
SATA Hot Plug SFF (2.5-inch) Midline (MDL) Drives
SATA Hot Plug LFF (3.5-inch) Midline (MDL) Drives
6G SAS ME Hot Plug SFF (2.5-inch) Enterprise Mainstream Solid State Drives
$489
$349.00
$601
$429.00
6G SAS SLC Hot Plug Enterprise Performance Solid State Drives
Networking
Gigabit Ethernet adapters
$161
$115.00
$72
$55.00
10 Gigabit Ethernet Adapters
NOTE: A minimum of two Gigabytes (2 GB) of server memory is required per each adapter.
NOTE: Direct Attach Cable (DAC) for copper environments or fiber transceivers and cables for fiber-optic environments must be purchased separately.
InfiniBand
Power Supplies
NOTE: - Prior to making a power supply selection it is highly recommended that the HPE Power Advisor is run to determine the right size power supply for your server configuration. The HPE Power Advisor is located at:- (link)

NOTE: Option Kits contain optional power supply, an IEC power cable and PDU IEC cables.
$184
$138.00
Storage Controllers
HPE Smart Array P212 Controller
HPE Smart Array P410 Controller
HPE Smart Array P411 Controller
$270
$203.00
$522
$399.00
Smart Array P812 Controller
Optional Upgrades

NOTE: This cable kit is only required when upgrading with a Smart Array P410 Controller after initial purchase.
NOTE: Supports SAS and SATA drives when using Smart Array P410 Controller.

NOTE: This cable kit is only required when upgrading with any Smart Array Controller other than the P410 after initial purchase.
$152
$114.00
NOTE: Supports SAS and SATA drives when using any Smart Array Controller other than the Smart Array P410 Controller.

NOTE: Supported on HPE Smart Array P212 Controller only.
$41
$29.00
$67
$48.00
$53
$39.00
SAS Controller Options
SCSI HBA
Tape Backup
$4,868
$3,606.00
$3,762
$2,675.00
Tape Storage Systems
HPE StoreEver MSL6480
$16,500
$12,500.00
Disk Storage Systems
Disk Enclosures
$8,768
$6,850.00
Storage Options
Storage Fibre Channel HBA
Brocade Fibre Channel HBAs
Emulex Fibre Channel HBAs
QLogic Fibre Channel HBAs
Converged Network Adapter
$177
$129.00
Rack Options
HPE TFT7600 G2 KVM Console and Monitor (TFT7600 G2)
HPE USB Keyboard and Mouse
HPE Server Console Switches
HPE Server Console Switch G2 with Virtual Media & CAC
HPE IP Console Switch G2 with Virtual Media & CAC
Rail Kits

NOTE: This kit is required after initial purchase when shipping a DL2000 in a rack with 1U or more of space above it from one location to another.
Processors
NOTE: HPE server processor pricing is volatile and availability is unpredictable. Please select any CPU kit below and click Request Quote and submit the form to get the current pricing for that CPU kit. |
NOTE: All CPU Kits come complete with heatsink, fan(s), etc