HPE ProLiant DL785 G5 Parts
Memory
$80
$55.00
$54
$45.00
$388
$292.00
NOTE: A minimum of two DIMMs (1 kit) must be installed per processor.
NOTE: Memory must be ordered in like-pairs, i.e. two of the same size.
NOTE: PC2-6400 memory modules are only supported on models configured with Opteron 8393 SE, 8389, 8387, 8384, 8380, 8378, 8381 HE and 8376HE processors. When only PC2-6400 DIMMs modules are installed with a processor then the memory bus speeds for 4 or fewer, 6 or 8 DIMMs per processor will operate at PC2-6400, PC2-5300 and PC2-4200 respectively. All other processor and memory configurations will operate at PC2-5300 with 4 or fewer DIMMs and PC2-4200 with 6 or more DIMMs.
Optical Media
NOTE: Optical drives are ejectable.
$194
$175.00
Drives
NOTE: Transfer rates of drives are dependent on the maximum transfer rate supported by the HBA or Controller. Refer to the HBA or Controller technical specifications for details.
NOTE: The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated down to an acceptable level for all components.
NOTE: All the internal drives in HPE ProLiant DL785 G5 will operate at a maximum data transfer rate of 3Gb/s.
SAS Hot Plug 2.5" SFF Enterprise (ENT) Drives
12G 15K Drives
12G = 12 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
12G 10K Drives
12G = 12 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
6G 15K Drives
6G = 6 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
6G 10K Drives
6G = 6 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
3G 15K Drives
3G = 3 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
3G 10K Drives
3G = 3 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
NOTE: Please see the SAS Hard Drive QuickSpecs for Technical Specifications such as capacity, height, width, interface, transfer rate, seek time, physical configuration, and operating temperature:
SAS Hot Plug 2.5" SFF Midline (MDL) Drives
$133
$95.00
$186
$128.00
Networking

NOTE: There is a maximum of five NC364T PCI Express Quad Port Gigabit Server Adapter NICs allowed in this server.
$165
$125.00

NOTE: Supported on a full length-full height slot only.
$56
$45.00

NOTE: A minimum of two Gigabytes (2 GB) of server memory is required per each NC522SFP adapter.
$92
$75.00
NOTE: Direct Attach Cable (DAC) for copper environments or fiber transceivers and cables for fiber-optic environments must be purchased separately.
Power Supplies
$274
$219.00
NOTE: Three additional power supply units are required for full redundancy.
Storage Controllers
SAS Controller
Smart Array E500 Controller
$392
$288.00
Smart Array P400 Controller
Smart Array P800 Controller
Smart Array P212 Controller
Smart Array P410 Controller
NOTE: AM436A HPE DL785 Smart Array Controller cable option kit is included when ordered on the DL785 with CTO factory integration.
NOTE: AM436A HPE DL785 Smart Array Controller cable option kit is required when the controller is ordered without factory integration and not connected to the 468406-B21 HPE SAS Expander Card.
Smart Array P411 Controller
Optional Upgrades

NOTE: This option kit contains a 24" battery cable and adhesive material for installing a battery into the server if a Smart Array E500 is integrated outside of the factory. For all solutions, please refer to the server QuickSpecs and User's Manual for detailed installation instructions.
$95
$75.00

NOTE: For Smart Array P400 Controller only.
NOTE: If you install the 512MB DDR BBWC as an upgrade to a Smart Array P400/256MB Controller, you must also order part 417836-B21 (HPE SA-P400 and SA-E500 24 In Battery Cable Kit).
$166
$129.00

NOTE: For Smart Array P400 Controller only.
NOTE: If you install the Battery-backed write cache as an upgrade to a Smart Array P400/256MB Controller, you must also order part 417836-B21 (HPE SA-P400 and SA-E500 24 In Battery Cable Kit).
$157
$118.00

NOTE: Supported on HPE Smart Array P212 Controller only.
$41
$29.00

NOTE: When used with the embedded HPE Smart Array P410i controller, this battery module also requires a 24 inch SFP Battery Cable (496029-B21).
$173
$129.00

NOTE: Option kit not supported for factory integration.
NOTE: To enable BBWC on the 256MB cache.
NOTE: Supported on HPE Smart Array P212 Controller, HPE Smart Array P410 Controller, and HPE Smart Array P411 Controller only.
$207
$156.00

NOTE: Option kit not supported for factory integration
NOTE: Supports internal connection of Smart Array P410 Controllers. Provides (2) cables to connect the Controller to the Optional SAS Backplane. Required each time one of the following is ordered without factory integration and will not be connected to the 468406-B21 HPE SAS Expander Card.
SAS Controller Options

NOTE: Option kit not supported for factory integration.
NOTE: Enables a single Smart Array P410 Controller to control all of the embedded HDD's. Allows the configuration of a RAID array with up to 16 embedded HDD's. The Controller must be installed in PCIe Slot 1 and the Expander in PCIe Slot 2. The embedded SA P400i controller is not used.
NOTE: AM440A HPE DL785 SAS Expander cable option kit required.
NOTE: Requires SA P410 Controller with Cache memory.
$233
$175.00

NOTE: Option kit not supported for factory integration
NOTE: Required each time the 468406-B21 HPE SAS Expander card is ordered.
Provides (6) cables to connect the Smart Array Controller to the Expander, and the Expander to the Primary and Optional SAS backplanes. The SAS cables provided with the DL785 and the Expander are not used.
SAS HBA
$140
$95.00
SCSI HBA

NOTE: Recommended HBA for SCSI tape drive connect.
$207
$149.00
SAS Option Kit

NOTE: The SAS Option Kit enables the second drive cage to support an additional eight SFF SAS hard disk drives, for a total internal support of sixteen SFF SAS hard disk drives.
NOTE: When choosing the HPE DL785 G5 SAS Option Kit, customer must also order one of the following Smart Array Controllers: HPE Smart Array P400 Controller, HPE Smart Array P800 Controller, or the HPE Smart Array P410 Controller.
Processors
NOTE: HPE server processor pricing is volatile and availability is unpredictable. Please select any CPU kit below and click Request Quote and submit the form to get the current pricing for that CPU kit. |
NOTE: All CPU Kits come complete with heatsink, fan(s), etc
$3,167
$2,850.00
$3,500
$3,150.00