HPE ProLiant ML350 G6 Hard Drives

HPE ProLiant ML350 G6 Hard Drives

HPE ProLiant ML350 G6 Hard Drives

Drives

NOTE: This server model can be configured to use either 2.5 inch Small Form Factor (SFF) drives OR 3.5 inch Large Form Factor drives. Please be sure to verify which type your machine is configured to use before placing an order. If you are unsure about which type you need, please visit the section #1 – Does my machine use 2.5 inch SFF or 3.5 inch LFF drives? in our blog post here for help making this decision.

SAS Hot Plug 2.5" SFF Enterprise (ENT) Drives

12G 15K Drives

12G 10K Drives

6G 15K Drives

6G 10K Drives

3G 15K Drives

3G 10K Drives

3G = 3 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
NOTE: Please see the SAS Hard Drive QuickSpecs for Technical Specifications such as capacity, height, width, interface, transfer rate, seek time, physical configuration, and operating temperature:
NOTE: Please note that SFF 2.5" (small form factor) drives can only be installed on tower or rack models with SFF chassis (models).

SAS Hot Plug 3.5" LFF Enterprise (ENT) Drives

SAS Hot Plug 3.5" Midline (MDL) Drives

SAS Hot Plug 2.5" SFF Midline (MDL) Drives

SATA Hot Plug 2.5" SFF Midline (MDL) Drives

SATA Hot Plug 2.5" SFF Entry (ETY) Drives

SATA Hot Plug 3.5" Midline (MDL) Drives

SATA Hot Plug 3.5" Entry (ETY) Drives

NOTE: The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated down to an acceptable level for all components.
Compare Selected