Sign In or Register
Sales & Support: 1-877-418-3246
0 ITEMS | $0.00 View Cart
 

HP ProLiant DL385p Gen8 Parts

Unique Options
HP DL380/DL385 Gen8 8 Small Form Factor Hard Drive Backplane Cage Kit
NOTE: With upgrade of 8SFF Cage/Bkpln, there is no Optical Drive support. 
NOTE: All cables necessary for proper installation of the 8SFF Cage are included with this Kit. 
NOTE: With upgrade of 8SFF Cage/Bkpln, an additional storage controller is required. Please go to the Storage Controller section for options available.
$294.00 $265.00
HP DL385p Gen8 x16 2x8 PCI-E Riser Kit
NOTE: 2nd Riser Cage requires 2nd Processor.
$442.00 $398.00
Back to top
Processors
Sixteen-Core Processors
NOTE: All support up to 1600MHz DDR3 memory speeds
Twelve-Core Processors
Eight-Core Processors
Quad-Core Processors
HP DL385p Gen8 AMD Opteron™ 6204 (3.3GHz/4-core/16MB/115W) Processor Kit
NOTE: Up to 2 processors supported in all models.
NOTE: DDR3 speed is the maximum memory speed of the processor. Actual memory speed may depend on the quantity and type of DIMMs installed.
$1,056.00 $950.00
Back to top
Memory
NOTE: To realize the performance memory capabilities for this server, HP SmartMemory is recommended. For additional information, please see the HP SmartMemory QuickSpecs at:
Registered DIMMs (RDIMMs)
Load Reduced DIMMs (LRDIMMs)
Ultra Low Voltage DIMMs (ULVDIMM) 
HP 16GB (1x16GB) Dual Rank x4 PC3U-10600R (DDR3-1333) Registered CAS-9 Ultra Low Voltage Memory Kit
NOTE: HP memory from previous generation servers may not provide the same performance with the HP ProLiant DL385p Gen8 Servers as HP SmartMemory will.
NOTE: If only one processor is installed, only half the DIMM slots are available. 
NOTE: Depending on the memory configuration, the memory speed may run at 1600MHz, 1333MHz, 1066MHz or lower. Please see Memory Population Table or the Online Memory Configuration Tool at: 
NOTE: All DDR3 memory option kits consist of one DIMM per kit. For detailed memory configuration rules and guidelines, please use the Online DDR3 Memory Configuration Tool: 
$404.00 $299.00
Back to top
Drives
NOTE: The HP ProLiant DL385p Gen8 Smart Storage solutions are equipped with entirely re-designed Small Form Factor (SFF 2.5 in) and Large Form Factor (LFF 3.5 in) hot plug carriers for HP Qualified Hard Drives and Solid State Drives. These new carriers provide status, location and activity indicators as well as caution indicators for "Do Not Remove". 
NOTE: The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated down to an acceptable level for all components.
SAS Hot Plug with Smart Drive SFF (2.5-inch) Enterprise Drives
12G 15K Drives
12G = 12 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
12G 10K Drives
12G = 12 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
6G 15K Drives
6G = 6 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
6G 10K Drives
6G = 6 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
SAS Hot Plug SmartDrive SFF (2.5-inch) Enterprise 512e Drives
SAS Hot Plug SmartDrive SFF (2.5-inch) Midline Drives
SAS Hot Plug SmartDrive LFF (3.5-inch) Enterprise Drives
SAS Hot Plug SmartDrive LFF (3.5-inch) Midline Drives
HP 1TB 6G SAS 7.2K rpm LFF (3.5-inch) SC Midline Hard Drive
NOTE: Please see the QuickSpecs for Technical Specifications and additional information: 
$361.00 $280.00
6G SATA Hot Plug with SmartDrive SFF (2.5-inch) Midline (MDL) Drives 
6G SATA Hot Plug with SmartDrive LFF (3.5-inch) Midline (MDL) Drives
HP 500GB 6G SATA 7.2K rpm LFF (3.5-inch) SC Midline Hard Drive S-Buy
NOTE: Please see the QuickSpecs for Technical Specifications and additional information: 
$354.00 $319.00
6G SAS ME Hot Plug SFF (2.5-inch) Enterprise Mainstream Solid State Drives
6G SAS SLC Hot Plug SFF (2.5-inch) Enterprise Performance Solid State Drives
3G SATA MLC Hot Plug SFF (2.5-inch) Enterprise Mainstream Solid State Drives
3G SATA MLC Hot Plug LFF (3.5-inch) Enterprise Mainstream Solid State Drives 
HP 100GB 3G SATA MLC LFF (3.5-inch) SC Enterprise Mainstream Solid State Drive
NOTE: Please see the QuickSpecs for Technical Specifications and additional information: 
$750.00 $728.00
Hard Drive Kits
NOTE: All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives ordered with the server.
Back to top
Networking
Gigabit Ethernet adapters
10 Gigabit Ethernet Adapters
NOTE: A minimum of two Gigabytes (2 GB) of server memory is required per each adapter.
NOTE: Direct Attach Cable (DAC) for copper environments or fiber transceivers and cables for fiber-optic environments must be purchased separately.
FlexibleLOM Adapters
HP Ethernet 10Gb 2-port 560SFP+ Adapter
NOTE: Please see the QuickSpecs for Technical Specifications and additional information: 
$631.00 $489.00
Back to top
InfiniBand
HP InfiniBand FDR/EN 10/40Gb Dual Port 544QSFP Adapter
NOTE: For the following two InfiniBand Adapters, only 1 FlexibleLOM can be added to the server, which is selected in Step 2 for the "Configuration Information - Factory Integrated Models" section. These two options are for upgrade or change from original configuration.
$826.00 $612.00
HP InfiniBand QDR/EN 10Gb Dual Port 544FLR-QSFP Adapter
NOTE: FLR Indicates new HP FlexibleLOM Adapter series.
NOTE: Please see the QuickSpecs for additional information:
$332.00 $246.00
Back to top
I/O Expansion Options
HP DL385p Gen8 x16 2x8 PCI-E Riser Kit
NOTE: 2nd Riser Cage requires 2nd Processor.
$442.00 $398.00
Back to top
Power Supplies
NOTE: Mixing of power supplies in the same server is not supported. All power supplies inside a server must be exactly the same model. Mixing Gold, Platinum, and Platinum Plus certified power supplies is not supported.
NOTE: Prior to making a power supply selection it is highly recommended that the HP Power Advisor is run to determine the right size power supply for your server configuration. The HP Power Advisor is located at:
HP Common Slot Platinum Plus Power Supply Kits 
NOTE: The following Power Supplies offer 94% Efficiency with support for Intelligent Power Discovery.
HP Common Slot Gold Power Supplies
NOTE: The following Power Supplies offer 92% Efficiency.
HP Common Slot -48VDC Power Supplies
NOTE: The following Power Supplies offer 92% Efficiency. 
HP 750W Common Slot -48VDC Hot Plug Power Supply Kit
NOTE: The HP 750W Common Slot -48VDC power supply does not ship with a power cable. It has been designed with a terminal block connection allowing for custom design of power cords by the user.
NOTE: Option Kits contain optional power supply, an IEC power cable and PDU IEC cables.
NOTE: Power Specification and Technical Content for supported power supplies can be found at:
$506.00 $455.00
Back to top
I/O Accelerator Options
Second Generation Accelerators
First Generation Accelerators
HP 160GB Single Level Cell PCIe ioDrive for ProLiant Servers 
NOTE: A low-profile PCI bracket is included for use in low-profile slots
$4,167.00 $3,750.00
HP 320GB Multi Level Cell PCIe ioDrive for ProLiant Servers
NOTE: A low-profile PCI bracket is included for use in low-profile slots.
$1,203.00 $891.00
HP 1.28TB Multi Level Cell PCIe ioDrive Duo for ProLiant Servers
NOTE: Please see the QuickSpecs for Technical Specifications and additional information: 
$3,320.00 $2,459.00
Back to top
Storage Controllers
SAS Controllers
Smart Array P222 Controller
Smart Array P420 Controller
Smart Array P421 Controller
Smart Array P822 Controller 
Optional Upgrades
HP Smart Array Advanced Pack 2.0 No Media Electronic Lic 1yr 24x7 Support Software
NOTE: RAID 6, 6+0 may be enabled with a combination of one cache upgrade and one Smart Array Advanced Pack from the options above.
Out of stock
HP Cable Options 
HP Mini SAS Straight to Straight 37in Cable Assembly
NOTE: Please see the QuickSpecs for Technical Specifications and additional information: 
(Smart Array P222 Controller)
(Smart Array P420 Controller) 
(Smart Array P421 Controller)
(Smart Array Advanced Pack)
$177.00 $159.00
Host Bus Adapter
SCSI HBA
HP SC11Xe Ultra320 Single Channel/ PCIe x4 SCSI Host Bus Adapter
NOTE: Please see the following QuickSpecs for additional information:
(SC11Xe HBA)
$299.00 $219.00
Back to top
Tape Backup
NOTE: For the complete range of tape drives, autoloaders, libraries and media see: http://www.hp.com/go/tape. For hardware and software compatibility of HP tape backup products see: https://h20272.www2.hp.com/spock/
Back to top
Rack Options
HP Location Discovery Services
HP 47U Location Discovery Kit
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
HP TFT7600 G2 KVM Console and Monitor (TFT7600 G2)
HP TFT7600 G2 KVM Console Rackmount Keyboard US TAA Monitor
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
HP USB Keyboard and Mouse
HP USB BFR with PVC Free US Keyboard/Mouse Kit
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
HP Server Console Switches
HP TAA 0x2x16xKVM Server Console G2 Switch
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
HP Server Console Switch G2 with Virtual Media & CAC
HP KVM CAT5 1-pack USB Interface Adapter
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
HP IP Console Switch G2 with Virtual Media & CAC
Rail Kits
NOTE: Rail kits are optional for Gen8 and are no longer included standard with the server(except pre-configured Models). The customer has the choice to not include rail kits with their server purchase, but it is recommended.
NOTE: HP 2U Ball Bearing Rail Kits provide full serviceability of the server while in the Rack and include a CMA. HP 2U Friction Rail Kits ARE NOT serviceable in the Rack and must be removed from the rack and do not include CMA.
NOTE: The HP 1U Gen8 Cable Management Arm is not available when using Friction Rails. To assist in the installation of the server into the rack an optional installation tool is available by contacting your local services representative (p/n 695539-001). Caution: HP recommends that a minimum of two people are required for all Rack Server installations. Please refer to your installation instructions for proper tools and number of people to use for any installation.
HP 2U Large Form Factor Ball Bearing Gen8 Rail Kit
NOTE: HP 2U Ball Bearing Rail Kits provide full serviceability of the server while in the Rack and include a CMA. HP 2U Friction Rail Kits ARE NOT serviceable in the Rack and must be removed from the rack and do not include CMA.
HP 2U Small Form Factor Ball Bearing Gen8 Rail Kit
NOTE: HP 2U Ball Bearing Rail Kits provide full serviceability of the server while in the Rack and include a CMA. HP 2U Friction Rail Kits ARE NOT serviceable in the Rack and must be removed from the rack and do not include CMA.
Back to top

Last updated: 8/24/2015

Need help finding the correct part? Live Chat operators are standing by. LET US HELP