HPE ProLiant DL385p Gen8 Parts
Unique Options
NOTE: With upgrade of 8SFF Cage/Bkpln, there is no Optical Drive support.
NOTE: All cables necessary for proper installation of the 8SFF Cage are included with this Kit.
NOTE: With upgrade of 8SFF Cage/Bkpln, an additional storage controller is required. Please go to the Storage Controller section for options available.
$173
$125.00
NOTE: 2nd Riser Cage requires 2nd Processor.
$313
$230.00
Memory
Registered DIMMs (RDIMMs)
$87
$61.00
$96
$78.00
$126
$99.00
$95
$69.00
$124
$87.00
$110
$82.00
Load Reduced DIMMs (LRDIMMs)
Ultra Low Voltage DIMMs (ULVDIMM)
$45
$32.00
$193
$139.00
HPE 16GB (1x16GB) Dual Rank x4 PC3U-10600R (DDR3-1333) Registered CAS-9 Ultra Low Voltage Memory Kit
NOTE: HPE memory from previous generation servers may not provide the same performance with the HPE ProLiant DL385p Gen8 Servers as HPE SmartMemory will.
NOTE: If only one processor is installed, only half the DIMM slots are available.
NOTE: Depending on the memory configuration, the memory speed may run at 1600MHz, 1333MHz, 1066MHz or lower. Please see Memory Population Table or the Online Memory Configuration Tool at:
NOTE: All DDR3 memory option kits consist of one DIMM per kit. For detailed memory configuration rules and guidelines, please use the Online DDR3 Memory Configuration Tool:
$106
$82.00
Optical Media
Drives
NOTE: The HPE ProLiant DL385p Gen8 Smart Storage solutions are equipped with entirely re-designed Small Form Factor (SFF 2.5 in) and Large Form Factor (LFF 3.5 in) hot plug carriers for HPE Qualified Hard Drives and Solid State Drives. These new carriers provide status, location and activity indicators as well as caution indicators for "Do Not Remove".
NOTE: The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated down to an acceptable level for all components.
SAS Hot Plug with Smart Drive SFF (2.5-inch) Enterprise Drives
12G 15K Drives
12G = 12 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
12G 10K Drives 
12G = 12 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
6G 15K Drives
6G = 6 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
6G 10K Drives
6G = 6 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
SAS Hot Plug SmartDrive SFF (2.5-inch) Enterprise 512e Drives
SAS Hot Plug SmartDrive SFF (2.5-inch) Midline Drives
SAS Hot Plug SmartDrive LFF (3.5-inch) Enterprise Drives
SAS Hot Plug SmartDrive LFF (3.5-inch) Midline Drives
6G SATA Hot Plug with SmartDrive SFF (2.5-inch) Midline (MDL) Drives
6G SATA Hot Plug with SmartDrive LFF (3.5-inch) Midline (MDL) Drives
6G SAS ME Hot Plug SFF (2.5-inch) Enterprise Mainstream Solid State Drives
$1,133
$776.00
$426
$304.00
6G SAS SLC Hot Plug SFF (2.5-inch) Enterprise Performance Solid State Drives
3G SATA MLC Hot Plug SFF (2.5-inch) Enterprise Mainstream Solid State Drives
$444
$302.00
$464
$329.00
3G SATA MLC Hot Plug LFF (3.5-inch) Enterprise Mainstream Solid State Drives
$668
$467.00
$427
$303.00
Hard Drive Kits
NOTE: All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives ordered with the server.
Networking
Gigabit Ethernet adapters
Quickspecs for 647594-B21 - 4 ports - RJ-45 - 10/100/1000 - PCI Express 2.0 x4
$145
$98.00
Quickspecs for 615732-B21 - 2 ports - RJ-45 - 10/100/1000 - PCI Express 2.0 x1
$84
$59.00
Quickspecs for 652497-B21 - 2 ports - RJ-45 - 10/100/1000 - PCI Express 2.0 x4
$185
$128.00
10 Gigabit Ethernet Adapters
NOTE: A minimum of two Gigabytes (2 GB) of server memory is required per each adapter.
NOTE: Direct Attach Cable (DAC) for copper environments or fiber transceivers and cables for fiber-optic environments must be purchased separately.
Quickspecs for 652503-B21 - 2 ports - SFP+ -10Gb+ - PCI Express 3.0 x8
$105
$75.00
FlexibleLOM Adapters
InfiniBand
NOTE: For the following two InfiniBand Adapters, only 1 FlexibleLOM can be added to the server, which is selected in Step 2 for the "Configuration Information - Factory Integrated Models" section. These two options are for upgrade or change from original configuration.
$128
$95.00
NOTE: FLR Indicates new HPE FlexibleLOM Adapter series.
$70
$49.00
I/O Expansion Options
NOTE: 2nd Riser Cage requires 2nd Processor.
$313
$230.00
Power Supplies
NOTE: Mixing of power supplies in the same server is not supported. All power supplies inside a server must be exactly the same model. Mixing Gold, Platinum, and Platinum Plus certified power supplies is not supported.
NOTE: Prior to making a power supply selection it is highly recommended that the HPE Power Advisor is run to determine the right size power supply for your server configuration. The HPE Power Advisor is located at:
HPE Common Slot Platinum Plus Power Supply Kits
NOTE: The following Power Supplies offer 94% efficiency with support for Intelligent Power Discovery.
HPE Common Slot Gold Power Supplies
NOTE: The following Power Supplies offer 92% efficiency.
HPE Common Slot -48VDC Power Supplies
NOTE: The following Power Supplies offer 92% Efficiency.
NOTE: The HPE 750W Common Slot -48VDC power supply does not ship with a power cable. It has been designed with a terminal block connection allowing for custom design of power cords by the user.
NOTE: Option Kits contain optional power supply, an IEC power cable and PDU IEC cables.
NOTE: Power Specification and Technical Content for supported power supplies can be found at:
$488
$399.00
I/O Accelerator Options
Second Generation Accelerators
First Generation Accelerators
NOTE: A low-profile PCI bracket is included for use in low-profile slots
$4,167
$3,750.00
NOTE: A low-profile PCI bracket is included for use in low-profile slots.
$949
$650.00
Storage Controllers
SAS Controllers
Smart Array P222 Controller
Smart Array P420 Controller
Smart Array P421 Controller
Smart Array P822 Controller
Optional Upgrades
$63
$45.00
NOTE: RAID 6, 6+0 may be enabled with a combination of one cache upgrade and one Smart Array Advanced Pack from the options above.
HPE Cable Options
Host Bus Adapter
$155
$112.00
$323
$236.00
$388
$266.00
SCSI HBA
Tape Backup
$1,389
$1,250.00
$2,122
$1,572.00
$1,250
$899.00
$4,868
$3,606.00
$3,322
$2,443.00
$2,625
$1,875.00
$1,428
$985.00
$1,980
$1,458.00
Storage Options
Storage Fibre Channel HBA
NOTE: For the complete listing of Fibre Channel Host Bus Adapters for Windows 2000, Windows Server 2003 and Linux, please see:
Brocade Fibre Channel HBAs
Emulex Fibre Channel HBAs
QLogic Fibre Channel HBAs
Converged Network Adapter
$177
$129.00
Rack Options
HPE Location Discovery Services
HPE TFT7600 G2 KVM Console and Monitor (TFT7600 G2)
HPE USB Keyboard and Mouse
HPE Server Console Switches
HPE Server Console Switch G2 with Virtual Media & CAC
HPE IP Console Switch G2 with Virtual Media & CAC
Rail Kits
NOTE: Rail kits are optional for Gen8 and are no longer included standard with the server(except pre-configured Models). The customer has the choice to not include rail kits with their server purchase, but it is recommended.
NOTE: HPE 2U Ball Bearing Rail Kits provide full serviceability of the server while in the Rack and include a CMA. HPE 2U Friction Rail Kits ARE NOT serviceable in the Rack and must be removed from the rack and do not include CMA.
NOTE: The HPE 1U Gen8 Cable Management Arm is not available when using Friction Rails. To assist in the installation of the server into the rack an optional installation tool is available by contacting your local services representative (p/n 695539-001). Caution: HPE recommends that a minimum of two people are required for all Rack Server installations. Please refer to your installation instructions for proper tools and number of people to use for any installation.
NOTE: HPE 2U Ball Bearing Rail Kits provide full serviceability of the server while in the Rack and include a CMA. HPE 2U Friction Rail Kits ARE NOT serviceable in the Rack and must be removed from the rack and do not include CMA.
$269
$199.00
NOTE: HPE 2U Ball Bearing Rail Kits provide full serviceability of the server while in the Rack and include a CMA. HPE 2U Friction Rail Kits ARE NOT serviceable in the Rack and must be removed from the rack and do not include CMA.
$269
$195.00
Processors
| NOTE: HPE server processor pricing is volatile and availability is unpredictable. Please select any CPU kit below and click Request Quote and submit the form to get the current pricing for that CPU kit. |
NOTE: All CPU Kits come complete with heatsink, fan(s), etc
Sixteen-Core Processors
NOTE: All support up to 1600MHz DDR3 memory speeds
$1,628
$1,274.00
Twelve-Core Processors
Eight-Core Processors
$1,686
$1,319.00
Quad-Core Processors
NOTE: Up to 2 processors supported in all models.
NOTE: DDR3 speed is the maximum memory speed of the processor. Actual memory speed may depend on the quantity and type of DIMMs installed.
$697
$545.00
Why Global One?
- Trusted by thousands. Over 32,000 customers in 100+ countries trust Global One Technology to deliver mission-critical HP Enterprise hardware - including Fortune 500 businesses, schools, hospitals, and federal, state, and local goverment agencies.
- HPE is our specialty! We only sell genuine HP Enterprise parts.
- EASY ordering process. Purchase online now with credit card or PayPal!
- FAST shipping. Global One Technology ships orders received by 5pm the same day and offers NEXT DAY delivery to US customers.
