Sign In or Register
Now shipping to over 100 countries worldwide!
0 ITEMS | $0.00 View Cart
 

HP ProLiant DL785 G5 Parts

Drives
NOTE: Transfer rates of drives are dependent on the maximum transfer rate supported by the HBA or Controller. Refer to the HBA or Controller technical specifications for details.
NOTE: The components of a storage subsystem (e.g. the drive, the HBA/controller, firmware, and the server backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated down to an acceptable level for all components.
NOTE: All the internal drives in HP ProLiant DL785 G5 will operate at a maximum data transfer rate of 3Gb/s.
SAS Hot Plug 2.5" SFF Enterprise (ENT) Drives
6G 15K Drives
6G 10K Drives
3G 15K Drives
3G 10K Drives
NOTE: Please see the SAS Hard Drive QuickSpecs for Technical Specifications such as capacity, height, width, interface, transfer rate, seek time, physical configuration, and operating temperature:
SAS Hot Plug 2.5" SFF Midline (MDL) Drives
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
Back to top
Networking
HP NC364T PCI Express Quad Port Gigabit Server Adapter
NOTE: There is a maximum of five NC364T PCI Express Quad Port Gigabit Server Adapter NICs allowed in this server.
$148.00 $114.00
HP NC380T PCI Express Dual Port Multifunction Gigabit Server Adapter
NOTE: Supported on a Full Length-Full Height slot only.
$118.00 $84.00
HP NC522SFP Dual Port 10GbE Server Adapter
NOTE: A minimum of two Gigabytes (2 GB) of server memory is required per each NC522SFP adapter.
$459.00 $325.00
NOTE: Direct Attach Cable (DAC) for copper environments or fiber transceivers and cables for fiber-optic environments must be purchased separately.
NOTE: Please see the QuickSpecs for Technical Specifications and additional information:
Back to top
Storage Controllers
SAS Controller
Smart Array E500 Controller
Smart Array P400 Controller
Smart Array P800 Controller
Smart Array P212 Controller
Smart Array P410 Controller
Smart Array P411 Controller
Optional Upgrades
HP SA-P400 and SA-E500 24 In Battery Cable Kit
NOTE: This option kit contains a 24" battery cable and adhesive material for installing a battery into the server if a Smart Array E500 is integrated outside of the factory. For all solutions, please refer to the server QuickSpecs and User's Manual for detailed installation instructions.
$99.00 $88.00
512MB Battery-backed write cache upgrade
NOTE: For Smart Array P400 Controller only.
NOTE: If you install the 512MB DDR BBWC as an upgrade to a Smart Array P400/256MB Controller, you must also order part 417836-B21 (HP SA-P400 and SA-E500 24 In Battery Cable Kit).
$77.00 $59.00
Battery-backed write cache upgrade
NOTE: For Smart Array P400 Controller only.
NOTE: If you install the Battery-backed write cache as an upgrade to a Smart Array P400/256MB Controller, you must also order part 417836-B21 (HP SA-P400 and SA-E500 24 In Battery Cable Kit).
$64.00 $49.00
256 MB Cache Module
NOTE: Supported on HP Smart Array P212 Controller only.
$44.00 $34.00
512MB BBWC
NOTE: When used with the embedded HP Smart Array P410i controller, this battery module also requires a 24 inch SFP Battery Cable (496029-B21).
$96.00 $74.00
Battery Kit upgrade
NOTE: Option kit not supported for factory integration.
NOTE: To enable BBWC on the 256MB cache.
NOTE: Supported on HP Smart Array P212 Controller, HP Smart Array P410 Controller, and HP Smart Array P411 Controller only.
$83.00 $64.00
HP DL785 Smart Array Controller cable option kit
NOTE: Option kit not supported for factory integration
NOTE: Supports internal connection of Smart Array P410 Controllers. Provides (2) cables to connect the Controller to the Optional SAS Backplane. Required each time one of the following is ordered without factory integration and will not be connected to the 468406-B21 HP SAS Expander Card.
SAS Controller Options
HP SAS Expander Card
NOTE: Option kit not supported for factory integration.
NOTE: Enables a single Smart Array P410 Controller to control all of the embedded HDD's. Allows the configuration of a RAID array with up to 16 embedded HDD's. The Controller must be installed in PCIe Slot 1 and the Expander in PCIe Slot 2. The embedded SA P400i controller is not used.
NOTE: AM440A HP DL785 SAS Expander cable option kit required.
NOTE: Requires SA P410 Controller with Cache memory.
$442.00 $398.00
HP DL785 SAS Expander cable option kit
NOTE: Option kit not supported for factory integration
NOTE: Required each time the 468406-B21 HP SAS Expander card is ordered.
Provides (6) cables to connect the Smart Array Controller to the Expander, and the Expander to the Primary and Optional SAS backplanes. The SAS cables provided with the DL785 and the Expander are not used.
NOTE: Please see the following Controller QuickSpecs for Technical Specifications and additional information:
SAS HBA
NOTE: Please see the following QuickSpecs for additional information:
SCSI HBA
HP SC11Xe Host Bus Adapter
NOTE: Recommended HBA for SCSI tape drive connect.
$299.00 $218.00
Back to top
SAS Option Kit
HP DL785 G5 SAS Option Kit
NOTE: The SAS Option Kit enables the second drive cage to support an additional eight SFF SAS hard disk drives, for a total internal support of sixteen SFF SAS hard disk drives.
Back to top

Last updated: 3/11/2015

Need help finding the correct part? Live Chat operators are standing by. LET US HELP
Accepted Credit Cards