HPE ProLiant BL465c Gen8 Parts
Networking
10Gb Ethernet Mezzanine
NOTE: Each 10 Gigabit Ethernet adapter requires a minimum of 2GB of server memory.
NOTE: A 10 Gigabit Ethernet adapter supports linking at 1Gbps or 10Gbps when connected to an interconnect module with 10Gb Ethernet downlinks.
NOTE: A 10 Gigabit Ethernet adapter supports linking at only 1Gbps when connected to an interconnect module with 1Gb Ethernet downlinks.
NOTE: The 10 Gigabit Ethernet adapters on each server blade connect to a 10Gb interconnect in bays 3-8 (HPE BladeSystem c7000 Enclosure) or bays 2-4 (HPE BladeSystem c3000 Enclosure).
1Gb Ethernet Mezzanine
FlexibleLOM Adapters
NOTE: The server supports one FlexibleLOM that is installed in the FlexibleLOM connector and is already included in Pre-configured Models and added per Step 2 for Factory Integrated Models. The FlexibleLOM options below are used to change these original FlexibleLOMs.
10Gb FlexibleLOM
Fiber Channel
Memory
NOTE: To realize the performance memory capabilities for this server, HPE SmartMemory is required. For additional information, please see the HPE SmartMemory QuickSpecs at:
NOTE: HPE memory from previous generation servers are not fully compatible with Smart Memory features in Gen8 Servers.
NOTE: A minimum of one DIMM is required per server.
NOTE: For additional memory rules and guidelines, see the "Memory" section of the Quickspecs document for this server.
HPE SmartMemory
Registered DIMMs (RDIMMs)
$87
$61.00
$96
$78.00
$126
$99.00
$95
$69.00
$124
$87.00
$110
$82.00
Load Reduced DIMMs (LRDIMMs)
Ultra Low Voltage DIMMs (ULVDIMM) for AMD Servers

$45
$32.00
$193
$139.00

HPE 16GB (1x16GB) Dual Rank x4 PC3U-10600R (DDR3-1333) Registered CAS-9 Ultra Low Voltage Memory Kit
NOTE: Depending on the memory configuration, 1600MHz and 1333MHz memory may operate at a lower speed. Please see the the Online Memory Configuration Tool for details at:
$106
$82.00
Drives
NOTE: The ProLiant BL465c Gen8 server includes the new HPE hot-plug small form factor (SFF) SmartDrive carrier for enhanced management and reduced maintenance errors. HPE drives from previous generation servers are not compatible with the BL465c Gen8 drive bays.
NOTE: The mixing of standard SAS drives with SAS SSD drives is supported within the server, but limits the RAID configuration to two separate RAID 0 volumes. Mixing of other drives types is not supported.
NOTE: The hard drive options are not required when configuring a drive-less model.
NOTE: Server supports only 3G SATA devices. The 6G SATA drives will negotiate to 3G speeds.
6G SATA Hot Plug with SmartDrive SFF (2.5-inch) Midline (MDL) Drives
SAS Hot Plug with Smart Drive SFF (2.5-inch) Enterprise Drives
12G 15K Drives
12G = 12 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
12G 10K Drives
12G = 12 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
6G 15K Drives
6G = 6 Gb/sec Transfer Rate Synchronous (Maximum)
15K = 15,000 rpm Rotational Speed
6G 10K Drives
6G = 6 Gb/sec Transfer Rate Synchronous (Maximum)
10K = 10,000 rpm Rotational Speed
SAS Hot Plug SmartDrive SFF (2.5-inch) Enterprise 512e Drives
SAS Hot Plug SmartDrive SFF (2.5-inch) Midline Drives
6G SAS ME Hot Plug SFF (2.5-inch) Enterprise Mainstream Solid State Drive
$1,133
$776.00
$426
$304.00
3G SATA MLC Hot Plug SFF (2.5-inch) Enterprise Mainstream Solid State Drives
$444
$302.00
$464
$329.00

NOTE: Servers supports only 3G SATA drives. The 6G SATA drives will negotiate to 3G speeds.
NOTE: The mixing of standard SAS drives with SAS SSD drives is supported within the server, but limits the RAID configuration to two separate RAID 0 volumes. Mixing of other drives types is not supported.
$399
$281.00
6G SAS SLC Hot Plug SFF (2.5-inch) Enterprise Performance Solid State Drives
Storage Controllers

HPE Smart Array P721m Controller
Optional Upgrades
InfiniBand Mezzanines
NOTE: When an InfiniBand adapter is installed in mezzanine slot 1, only one port is active (regardless of operating mode). When installed in any other mezzanine slot, both ports are active.
NOTE: On PCIe Gen2 based servers like BL465 Gen8, InfiniBand FDR speeds are not feasible.

NOTE: The QDR InfiniBand adapter may be installed in any mezzanine slot of the server.
$91
$65.00

NOTE: The FDR InfiniBand adapter must be installed in mezzanine slot 1 for FDR mode and may be installed in any mezzanine slot if operated in any other mode.
$210
$158.00
Ultrium Tape Blades

NOTE: LTO-4 Ultrium tape technology.

NOTE: LTO-5 Ultrium tape technology.
$7,222
$6,500.00
Storage Blades
$1,292
$950.00
Expansion Blade

NOTE: The PCI Expansion Blade provides PCI card slots for an adjacent c-Class Server Blade. Order one PCI expansion Blade for each server blade needing standard PCI-X or PCIe expansion slots.
NOTE: Ships with one pre-installed PCI-X connect board. Also includes one PCIe connect board which requires installation.
$359
$246.00
Processors
NOTE: HPE server processor pricing is volatile and availability is unpredictable. Please select any CPU kit below and click Request Quote and submit the form to get the current pricing for that CPU kit. |
NOTE: All CPU Kits come complete with heatsink, fan(s), etc
NOTE: The BL465c Gen8 supports one or two processors.
NOTE: All processors within the server must be identical.
NOTE: The letters HE following the model number denotes lower wattage.
NOTE: The memory configuration determines the maximum speed memory can operate. Please see the see the Memory section later in this document.
Sixteen-Core Processors
$1,673
$1,195.00
$1,813
$1,295.00
$1,522
$1,185.00
Twelve-Core Processors
Eight-Core Processors
$1,483
$1,059.00