HPE ProLiant BL2x220c G6 Parts
Unique Options
$181
$137.00
Ethernet Mezzanine Options
Gigabit Ethernet Mezzanines
NOTE: If the NC325m is installed in mezzanine slot 1 of a half-height server, connectivity will be provided on 2 of the 4 ports.
$91
$72.00
$81
$60.00
NOTE: If the NC364m is installed in mezzanine slot 1 of a half-height server, connectivity will be provided on only 2 of the 4 ports.
NOTE: The Gigabit Ethernet adapters above transmit from the server at 2000 Mbps, full duplex per port only. For more information, see the "Network Controller" segment in the Standards Features section.
10 Gigabit Ethernet Mezzanines
NOTE: A 10 Gigabit Ethernet adapter is required for each server blade connecting to a 10Gb interconnect in bays 3-8 (HPE BladeSystem c7000 Enclosure) or bays 2-4 (HPE BladeSystem c3000 Enclosure).
NOTE: Each 10 Gigabit Ethernet adapter requires a minimum of 2GB of server memory.
NOTE: Each 10 Gigabit Either adapter supports linking at 1000Mbps or 10000Mbps when not connected to a Flex-10 enabled module and will link with all current 1Gb switches at 1Gb.
NOTE: The ROM Based Setup Utility (RBSU) feature allows for the configuring of a FlexFabric Adapter to any of the supported protocols. For example iSCSI to FCoE (Fibre Channel over Ethernet). Note that a HPE Virtual Connect profile takes precedence over the setting in this menu. Also, some FlexFabric Adapters may require that network boot be enabled in order to configure the protocol. If the protocol is configured without enabling network boot with certain FlexFabric Adapters, the protocol may not take effect. Once the protocol has taken effect on the first boot after configuring this option, network boot may be disabled if desired.
$498
$395.00
$146
$98.00
Fibre Channel Mezzanine Options
4Gb Fibre Channel Mezzanine Cards
Memory
Registered DIMMs (RDIMMs)
$49
$38.00
$54
$38.00
$50
$39.00
$93
$65.00
$81
$65.00
NOTE: Low Voltage DIMMs can only be used with Intel Xeon 5600 series processors.
$56
$39.00
NOTE: Low Voltage DIMMs can only be used with Intel Xeon 5600 series processors.
Unbuffered with ECC DIMMs (UDIMMs)
$57
$38.00
$66
$45.00
$67
$48.00
NOTE: All DDR3 memory option kits consist of one DIMM per kit.
NOTE: Kits described as LP include Low Power DIMMs.
NOTE: PC3L is a low voltage memory.
Drives
NOTE: The components of a storage subsystem (e.g. the drive, the HBA/controller, and the server backplane) should operate at the same data transfer rate or the system bandwidth will be negotiated down to an acceptable level for all components.
SATA Non-Hot Plug Solid State Drive (SSD)
NOTE: One per server node.
SATA Non-Hot Plug SFF (2.5-inch) Entry (ETY) Drives
NOTE: One per server node.
Storage Controllers
HPE Smart Array P700 Controller
I/O Expansion Options
c-Class Mezzanine Options
NOTE: Only a single port can be used on the BL2x220c.
$213
$149.00