HPE ProLiant DL380 G7 Power Supplies

HPE ProLiant DL380 G7 Power Supplies

HPE ProLiant DL380 G7 Power Supplies

Genuine HPE Common Slot hot-plug power supplies for the HPE ProLiant DL380 G7, new and refurbished. One rule governs every order on this page: HPE does not support mixing power supplies in the same server — both units must match on output and on efficiency rating, or the server reports errors.

DL380 G7 Power Supply Specifications

  • Format: HPE Common Slot (CS) hot-plug supplies, the shared form factor used across several ProLiant generations
  • Efficiency: rated up to 94%, in Platinum and Gold efficiency grades
  • Outputs stocked: 460W, 750W and 1200W, so the supply can be sized to the configuration rather than over-specified
  • DC option: a 1200W Common Slot −48VDC unit for racks fed by DC rectifiers, supplied with a −48V DC cord
  • Redundancy: optional 1+1 or N+N redundant configurations through power supply option kits
  • Mixing: not supported — all supplies in one server must share the same output and efficiency rating
  • Cooling: fully redundant hot-plug fans ship as standard in an N+1 arrangement, four on single-processor models and six on dual-processor models

Mixing power supplies is not supported. HPE requires every supply in one server to share the same output and the same efficiency rating — two 750W units are still a mismatch if one is Platinum and the other Gold. Read the label on the installed unit before ordering the second.

Which Wattage Does Your Configuration Need?

OutputGrades stockedSuits
460WPlatinum, GoldSingle processor, modest drive count, no add-in accelerators
750WPlatinum, GoldTwo processors with a populated SFF cage — the common choice
1200WPlatinum, −48VDCTwo high-wattage processors, sixteen drives and several PCIe cards

Oversizing costs efficiency as well as money: a supply running far below its rated load sits away from its best efficiency point. HPE publishes a Power Advisor for sizing a specific configuration, and for a server of this age the honest shortcut is to match what is already fitted unless the machine has gained processors or drives since.

Choosing the Right DL380 G7 Power Supply

  • Read the label on the installed unit first. Matching output and efficiency grade is a requirement, not a preference, so the existing supply is the specification.
  • Platinum and Gold do not mix. Two 750W units are still a mismatch if one is Platinum and the other Gold.
  • Redundancy needs two matching units. A 1+1 configuration is two identical supplies; a single supply in a two-bay chassis is not redundant, whatever its rating.
  • −48VDC is a different world. The DC unit belongs in racks fed by DC rectifiers and ships with a DC cord; it is not an alternative to an AC supply on a standard rack feed.

Complete Your DL380 G7 Build

Power draw follows the processors and the drive count — see DL380 G7 processors and hard drives before sizing a supply. Also available: DL380 G7 memory, storage controllers and networking adapters, or the full DL380 G7 parts listing.

DL380 G7 Power Supplies FAQ

Can I mix power supplies in a DL380 G7?
No. HPE states that all power supplies in one server must be of the same output and efficiency rating. Mismatched units produce errors rather than running at the lower rating.

What wattage power supply does a DL380 G7 need?
It depends on the configuration. 460W suits a lightly loaded single-processor server, 750W covers most two-processor builds with a full SFF cage, and 1200W is for heavily populated machines.

Are DL380 G7 power supplies hot-plug?
Yes. The Common Slot supplies are hot-plug, and in a redundant pair one can be replaced while the server continues to run.

What is the difference between Platinum and Gold?
They are efficiency grades, with Platinum the higher of the two. Both are available at 460W and 750W for this server, but the two grades cannot be mixed in one chassis.

What is the minus 48VDC power supply for?
Racks fed by DC power rectifiers rather than an AC supply, as found in some telecommunications environments. It ships with a minus 48V DC cord and is not interchangeable with the AC units.

How many fans does a DL380 G7 have?
Fully redundant hot-plug fans ship as standard in an N+1 arrangement: four fans on single-processor models, and six on models with a second processor fitted.

Looking for a specific DL380 G7 power supply? Browse our full selection below.

Parts Finder Narrow to your model…
Compare Selected